Mam problem z połączeniem się dirver E z SKRv1.3. Jest napisane na wyświetlaczu "TMC connect ERROR" po wysłaniu komendy M122 jest problem z ekstruderem
Kod: Zaznacz cały
>>> M122
SENDING:M122
X Y Z E
Address 0 0 0 0
Enabled false false false false
Set current 580 580 580 650
RMS current 550 550 550 1160
MAX current 776 776 776 1636
Run current 17/31 17/31 17/31 20/31
Hold current 8/31 8/31 8/31 10/31
CS actual 8/31 8/31 8/31 0/31
PWM scale 42 10 10 0
vsense 1=.18 1=.18 1=.18 0=.325
stealthChop true true true false
msteps 16 16 16 256
tstep max max max 0
pwm
threshold
[mm/s]
OT prewarn false false false false
off time 4 4 4 0
blank time 24 24 24 16
hysteresis
-end 2 2 2 -3
-start 1 1 1 1
Stallguard thrs 0 0 0 0
DRVSTATUS X Y Z E
stst * * *
olb
ola
s2gb
s2ga
otpw
ot
157C
150C
143C
120C
s2vsa
s2vsb
Driver registers:
X 0xC0:08:00:00
Y 0xC0:08:00:00
Z 0xC0:08:00:00
E 0x00:00:00:00 Bad response!
Testing X connection... OK
Testing Y connection... OK
Testing Z connection... OK
Testing E connection... Error: All LOW
Proszę o pomoc