Nie mogę coś dojść do ładu i składu. Prawdopodobnie mam coś namieszane z kolejnością albo czymś innym. Problem występuje tylko przy włączeniu zasilania, jak przez DWC wcisnę "emergancy stop" to po wczytaniu strony status grzałki jest off.
Tu jest moja konfiguracja do grzałki od komory:
Kod: Zaznacz cały
M308 S2 P"e1temp" Y"thermistor" R4700 A"Chamber bot"
; Chamber Heater
M950 H4 C"exp.heater4" T2 ; heater 0 uses the bed_heat pin, sensor 0
M141 H4
; Chamber
M308 S10 P"spi.cs1" Y"dht11" A"Chamber top" ; define DHT22 temperature sensor
M308 S11 P"S10.1" Y"dhthumidity" A"Chamber Hum[%]" ; Attach DHT22 humidity sensor to secondary output of temperature sensor
M950 F2 C"fan2" Q60
M143 H4 S50 T10 ; Set temperature limit for heater 0 to 120C
M307 H4 B1 R0.145 C372.6 D49.14 S1.00 V24.5
M106 C"Chamber fan" P2 S0