udało mi się jak do tej pory dojść do stanu w którym po udanym G28 zwykle drukarka wyłącza Klippera - komunikuje jeden z losowych komunikatów
Na tę chwilę obecną oba TMC5160 są zasilane ze wspólnego zasilacza zasilacza 24V.
Wiem że plyty RUMBA32 mają błąd w laminacie więc zrobiłem na płycie mostki zgodnie z tutorialami
https://github.com/makerbase-mks/MKS-RUMBA32/issues/2
lub trochę inaczej
https://github.com/Aus3D/RUMBA32/issues/23
W obu przypadkach mam identyczne objawy i problem. Czy macie jakieś pomysły gdzie szukać dalej rozwiązania?
Tu losowo pojawiające się zwisy KLIPPERA:
Kod: Zaznacz cały
Klipper reports: SHUTDOWN
TMC 'stepper_y' reports error: GSTAT: 00000001 reset=1(Reset)
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown
lub
TMC 'stepper_y' reports error: GSTAT: ffffffff reset=1(Reset) drv_err=1(ErrorShutdown!) uv_cp=1(Undervoltage!)
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown
lub
TMC 'stepper_x' reports error: GSTAT: 00000001 reset=1(Reset)
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown