Kod: Zaznacz cały
# Define the BLTouch servo
[servo bltouch]
pin: ar11
maximum_servo_angle: 180
minimum_pulse_width: 0.0006
maximum_pulse_width: 0.0024
# Define a probe using the BLTouch
[probe]
pin: ar18
z_offset: 0.15
activate_gcode:
SET_SERVO SERVO=bltouch ANGLE=10
SET_SERVO SERVO=bltouch ANGLE=60
G4 P200
deactivate_gcode:
SET_SERVO SERVO=bltouch ANGLE=90
G4 P100
# Mesh Bed Leveling. One may define a [bed_mesh] config section
# to enable move transformations that offset the z axis based
# on a mesh generated from probed points. Note that bed_mesh
# and bed_tilt are incompatible, both cannot be defined.
[bed_mesh]
speed: 120
# The speed (in mm/s) of non-probing moves during the
# calibration. The default is 50.
horizontal_move_z: 10
# The height (in mm) that the head should be commanded to move to
# just prior to starting a probe operation. The default is 5.
samples: 1
# The number of times to probe each point. The probed z-values
# will be averaged. The default is to probe 1 time.
sample_retract_dist: 5.0
# The distance (in mm) to retract between each sample if
# sampling more than once. Default is 2mm.
min_point: 30,10
# An X,Y point defining the minimum coordinate to probe on
# the bed. Note that this refers to the nozzle position,
# and take care that you do not define a point that will move
# the probe off of the bed. This parameter must be provided.
max_point: 295,260
# An X,Y point defining the maximum coordinate to probe on
# the bed. Follow the same precautions as listed in min_point.
# Also note that this does not necessarily define the last point
# probed, only the maximum coordinate. This parameter must be provided.
probe_count: 5,5
# A comma separated pair of integer values (X,Y) defining the number
# of points to probe along each axis. A single value is also valid,
# in which case that value will be for both axes. Default is 3,3
# which probes a 3x3 grid.
fade_start: 300.0
# The z-axis position in which to start phasing z-adjustment out.
# Default is 1.0.
#fade_end: 300.0
# The z-axis position in which phase out is complete. If this
# value is less than or equal to fade_start then phasing out
# is disabled. Default is 10.0.
split_delta_z: .025
# The amount of Z difference (in mm) along a move that will
# trigger a split. Default is .025.
move_check_distance: 5.0
# The distance (in mm) along a move to check for split_delta_z.
# This is also the minimum length that a move can be split. Default
# is 5.0.
mesh_pps: 2,2
# A comma separated pair of integers (X,Y) defining the number of
# points per segment to interpolate in the mesh along each axis. A
# "segment" can be defined as the space between each probed
# point. The user may enter a single value which will be applied
# to both axes. Default is 2,2.
algorithm: bicubic
# The interpolation algorithm to use. May be either "lagrange"
# or "bicubic". This option will not affect 3x3 grids, which
# are forced to use lagrange sampling. Default is lagrange.
bicubic_tension: .2
# When using the bicubic algorithm the tension parameter above
# may be applied to change the amount of slope interpolated.
# Larger numbers will increase the amount of slope, which
# results in more curvature in the mesh. Default is .2.