Silniki są równolegle podłączone do oryginalnej płytki sterującej ( opartej na A4982 ). Prąd na silniki jest ustawiony na 1.75A ( już podkręcałem ). W osi Z są też śruby trapezowe TR8x8.
Silniki w Z to SL42STH40-1684A-23
Spróbuję jeszcze zrobić 2 testy i pytanie do Was koledzy czy macie jakieś lepsze sugestie:
1. Spróbuję podłączyć silniki szeregowo zamiast równolegle
2. Jak to niepomoże zamienię TR8x8 na TR8x1 od TDI-CAD-a żeby zmniejszyć obciązenie na silnikach
Odnośnie softu: Marlin dostarczony z x5s z następującymi ustawieniami odnośnie silników:
Kod: Zaznacz cały
// default settings
#define DEFAULT_AXIS_STEPS_PER_UNIT {80,80,400,90} // default steps per unit for Ultimaker
#define DEFAULT_MAX_FEEDRATE {400, 400, 4, 50} // (mm/sec)
#define DEFAULT_MAX_ACCELERATION {1000,1000,1000,1000} // X, Y, Z, E maximum start speed for accelerated moves. E default values are good for Skeinforge 40+, for older versions raise them a lot.
#define DEFAULT_ACCELERATION 1000 // X, Y, Z and E acceleration in mm/s^2 for printing moves
#define DEFAULT_RETRACT_ACCELERATION 1000 // E acceleration in mm/s^2 for retracts
#define DEFAULT_TRAVEL_ACCELERATION 1000 // X, Y, Z acceleration in mm/s^2 for travel (non printing) moves
// The speed change that does not require acceleration (i.e. the software might assume it can be done instantaneously)
#define DEFAULT_XYJERK 20.0 // (mm/sec)
#define DEFAULT_ZJERK 0.4 // (mm/sec)
#define DEFAULT_EJERK 5.0 // (mm/sec)