Re: mój pierwszy raz
: 30 lis 2019, 00:19
HA! wiedziałam, że gdzieś coś dzwoni - w FAQ:
https://learn.watterott.com/silentstepstick/faq/
jest wspomniane:
" On 3D printers sometimes two stepper motors are used for the Z axis and connected to one stepper driver. A series connection of the motors is in most cases better than a parallel connection. Only for motors with a high phase voltage (>6V) a parallel connection should be used and the double current has to be set for a parallel connection."
więc wg. Watterott na osi Z warto podłączyć oba silniki szeregowo!
( Minebea 17pm-j342-g3vs mają w spec. 1,76V na fazę, więc łapią się na ten wariant)
Gdzieś widziałam jak się toto szeregowo łączy... ha, mam:
https://www.instructables.com/id/Wiring ... in-Series/
https://learn.watterott.com/silentstepstick/faq/
jest wspomniane:
" On 3D printers sometimes two stepper motors are used for the Z axis and connected to one stepper driver. A series connection of the motors is in most cases better than a parallel connection. Only for motors with a high phase voltage (>6V) a parallel connection should be used and the double current has to be set for a parallel connection."
więc wg. Watterott na osi Z warto podłączyć oba silniki szeregowo!
( Minebea 17pm-j342-g3vs mają w spec. 1,76V na fazę, więc łapią się na ten wariant)
Gdzieś widziałam jak się toto szeregowo łączy... ha, mam:
https://www.instructables.com/id/Wiring ... in-Series/